RUSTOLEUM NEVERWET Υλικό δύο στρωμάτων που αδιαβροχοποιεί ποικιλία επιφανειών 400ml

Rust-Oleum® NeverWet®

is a superhydrophobic coating

system designed to create a protective barrier to repel

water, ice, mud and other liquids. This revolutionary

coating causes water to form nearly perfect spheres which

roll off the surface keeping assets clean and dry.

NeverWet can be used on metal, concrete, masonry,

wood, vinyl and more. This product can be used indoors

and out. NeverWet coating sprays on clear and dries to a

flat light haze.

This product is intended for air atomized spray application

only.

This product complies with USDA FSIS regulatory

sanitation performance standards for meat and poultry

establishments.

.PRODUCTS .

SKU Description

275636 1-Gallon Base Coat

275612 1-Gallon Topcoat

277248 2-Gallon Kit

PRODUCT APPLICATION .

SURFACE PREPARATION

Surfaces must be dry, clean and free of dirt, oil, grease,

wax, dust, chalk, rust or any other contaminants that may

prevent proper adhesion. Remove all loose or peeling

paint. Plaster, concrete block, concrete and masonry

surfaces must be cured. Remove all form release and

curing agents.

.PRODUCT APPLICATION (cont.) .

APPLICATION

Mix basecoat thoroughly with a powered mixer or paint

shaker. Stir often during use. Thoroughly shake topcoat

before use. Remove lid with care. Apply only when air and

surface temperatures are between 50-90°F (10-32°C) and

the relative humidity is not greater than 85%. Dry times

may be affected by extremely high or low relative humidity.

Base Coat - Spray apply a continuous wet film free from

sags and runs. Wait 45 minutes.

Topcoat – Spray apply several light coats until a cloudy,

slightly hazy film is evident. Water repellency will start

after 30 minutes with optimum performance after 12 hours.

EQUIPMENT RECOMMENDATIONS

AIR-ATOMIZED SPRAY:

Equipment Tip Size Air Pressure Pot Pressure Delivery Rate

Siphon Feed 0.055 45 psi NA 10 fluid oz./min.

Gravity Feed 0.055 45 psi NA 10 fluid oz./min.

HVLP Siphon 0.055 50 psi NA 4 fluid oz./min.

Pressure Feed 0.055 45 psi 5 psi 12 fluid oz./min.

THINNING

DO NOT THIN.

CLEAN UP

Use soap and water immediately after use. Flush spray

lines immediately with water, followed by Rust-Oleum

Thinner #160402, mineral spirits or Krud Kutter® Cleaner

Degreaser.