TO XRO.MA HYPER LINE High quality matt emulsion paint 10L - WHITE

Technical properties

• Color: White, 8 basic shades and unlimited number of shades through the THE XRO.MA COLOR SYSTEM.

• Density: 1.46 ± 0.05 g/ml (EN ISO 2811-1)

• Viscosity: 115 ± 5 KU (ASTM D 562)

• pH: 8-9.5 (EN ISO 19396-1)

• Water Vapor Permeability: Sd=0.24±0.02 m (EN ISO 7783, 0.14 <Sd<1.4, medium class II)

• Water Permeability: w=0.07 ± 0.02 kg. / m2h 0.5 (EN ISO 1062-3, W3 low, w< 0,10 kg/m2h0,5)

• Adhesion: ≥1.70 MPa (EN ISO 4624)

• Gloss value: < 5, Dead Matt (EN ISO 2813: <5, at 85˚)

• Opacity: ≥ 98.5% (EN ISO 6504-3) (consumption ≥11 m²/l)

• Whiteness: ≥ 89 (EN ISO 6504-3)

• Wet-scrub resistance: CLASS 1 (EN ISO 11998: <5 μm in 200 wash cycles)

• Touch dry: ½ -1 hour (+23ºC)

• Time to repaint: 3-4 hours (+23ºC)

Substrate Preparation

PLASTIC SUPER is applied in interior substrates like gypsum boards, plasters, concrete to older and new surfaces after their priming with adequate primer. Substrate should be clean and free of loose materials or dust and grease or oily materials etc. that can create lower adherence. Any other cracks or voids on the substrate should be filled with acrylic sealant or adequate products. Application of Acrylic Primer diluted with water to 1:3 till 1:4 follows as primer. In case of Gypsum Board the use of Acrylic Gypsum Board Primer is suggested with a 10% dilution with water. Otherwise in case of a Water paint or very loose material or high dust substrate a Micronized Acrylic Primer is suggested for use after a 50 % dilution with water. Depending on the absorption of substrate a 100-200 g/m2 of diluted primer is recommended. In case the surface is in good condition from older application with same type/ quality of paint the priming stage could be avoided.

Products Application

PLASTIC SUPER is diluted with potable water 5-10% and stirred smoothly. It is applied in 2 layers and the best result is managed with a consumption of 12 m2 /lt per layer.

Rolles brushes and airless guns might be used for product applications and should be cleaned with water and detergents immediately after application.

Application of the product should be avoided if temperature is above or lower than 7-35 oC and humidity exceeds 80% due to probable effect on product properties.

PLASTIC SUPER is supplied in containers of 0.75lt, 3 lt, 10 lt. Shelf Life -Storage Conditions The product has a shelf life of 24 months in tight closed canisters and should be stored between 5- 35oC, also avoid exposure of packaging to direct

sunlight and frost.